Sticker Application Instructions
Here are the decal application instructions on how to apply Evil One® biker decals and stickers:
1) Clean the area thoroughly with rubbing alcohol or soap and water and then completely dry the area. Do Not use Windex or other similar cleaners as this will prevent the sticker from adhering as well
2) Prepare the sticker for application by removing the backing (it is the thinner paper-ish piece that you can easiest see through)
3) Place the sticker in the desired location and firmly rub a credit card or squeegee across the remaining semi-transparent side (this will help remove any air bubbles)
4) It is best to wait 24 hours before removing the semi-transparent side. After 24 hours you should again firmly rub a credit card or squeegee across the semi-transparent side and then slowly it peel it off at an angle …
NOTES: Be gentle so you do not pull the sticker off the surface and go slowly so if the sticker starts to pull away, you can push it down with the semi-transparent. Use a pin to poke any air bubbles in the center and push the air out through the hole. To get the best results apply in moderate temperatures.
Showing all 3 results